Noise is unwanted sound judged to be unpleasant, loud or disruptive to hearing. From a physics standpoint, noise is indistinguishable from sound, as both are vibrations through a medium, such as air or water. The difference arises when the brain receives and perceives a sound.
Acoustic noise is any sound in the acoustic domain, either deliberate (e.g., music or speech) or unintended. In contrast, noise in electronics may not be audible to the human ear and may require instruments for detection.
In audio engineering, noise can refer to the unwanted residual electronic noise signal that gives rise to acoustic noise heard as a hiss. This signal noise is commonly measured using A-weighting or ITU-R 468 weighting.
Sound is measured based on the amplitude and frequency of a sound wave. Amplitude measures how forceful the wave is. The energy in a sound wave is measured in decibels (dB), the measure of loudness, or intensity of a sound; this measurement describes the amplitude of a sound wave. Decibels (dB) are expressed in a logarithmic scale. On the other hand, pitch describes the frequency of a sound and is measured in hertz (Hz).
The main instrument to measure sounds in the air is the Sound Level Meter. There are many different varieties of instruments that are used to measure noise - Noise Dosimeters are often used in occupational environments, noise monitors are used to measure environmental noise and noise pollution, and recently smartphone-based sound level meter applications (apps) are being used to crowdsource and map recreational and community noise.
A-weighting is applied to a sound spectrum to represent the sound that humans are capable of hearing at each frequency. Sound pressure is thus expressed in terms of dBA. 0 dBA is the softest level that a person can hear. Normal speaking voices are around 65 dBA. A rock concert can be about 120 dBA.
In audio, recording, and broadcast systems, audio noise refers to the residual low-level sound (four major types: hiss, rumble, crackle, and hum) that is heard in quiet periods of program. This variation from the expected pure sound or silence can be caused by the audio recording equipment, the instrument, or ambient noise in the recording room.
In audio engineering it can refer either to the acoustic noise from loudspeakers or to the unwanted residual electronic noise signal that gives rise to acoustic noise heard as 'hiss'. This signal noise is commonly measured using A-weighting or ITU-R 468 weighting
Noise is often generated deliberately and used as a test signal for audio recording and reproduction equipment.
White noise is energy randomly spread across a wide frequency band containing all notes from high to low. It is called "white" noise as it is analogous to "white" light which contains all the colors of the visible spectrum.
Environmental noise is the accumulation of all noise present in a specified environment. The principal sources of environmental noise are surface motor vehicles, aircraft, trains and industrial sources. These noise sources expose millions of people to noise pollution that creates not only annoyance, but also significant health consequences such as elevated incidence of hearing loss and cardiovascular disease. There are a variety of mitigation strategies and controls available to reduce sound levels including source intensity reduction, land-use planning strategies, noise barriers and sound baffles, time of day use regimens, vehicle operational controls and architectural acoustics design measures.
Certain geographic areas or specific occupations may be at a higher risk of being exposed to constantly high levels of noise; in order to prevent negative health outcomes, regulations may be set. Noise regulation includes statutes or guidelines relating to sound transmission established by national, state or provincial and municipal levels of government. Environmental noise is governed by laws and standards which set maximum recommended levels of noise for specific land uses, such as residential areas, areas of outstanding natural beauty, or schools. These standards usually specify measurement using a weighting filter, most often A-weighting.
In 1972, the Noise Control Act was passed to promote a healthy living environment for all Americans, where noise does not pose a threat to human health. This policy's main objectives were: (1) establish coordination of research in the area of noise control, (2) establish federal standards on noise emission for commercial products, and (3) promote public awareness about noise emission and reduction.
The Quiet Communities Act of 1978 promotes noise control programs at the state and local level and developed a research program on noise control. Both laws authorized the Environmental Protection Agency to study the effects of noise and evaluate regulations regarding noise control.
The National Institute of Occupational Safety and Health (NIOSH) provides recommendation on noise exposure in the workplace. In 1972 (revised in 1998), NIOSH published a document outlining recommended standards relating to the occupational exposure to noise, with the purpose of reducing the risk of developing permanent hearing loss related to exposure at work. This publication set the recommended exposure limit (REL) of noise in an occupation setting to 85 dBA for 8 hours using a 3-dB exchange rate (every 3-dB increase in level, duration of exposure should be cut in half, i.e. 88 dBA for 4 hours, 91 dBA for 2 hours, 94 dBA for 1 hour, etc.). However, in 1973 the Occupational Safety and Health Administration (OSHA) maintained the requirement of an 8-hour average of 90 dBA. The following year, OSHA required employers to provide a hearing conservation program to workers exposed to 85 dBA average 8-hour workdays.
The European Environment Agency regulates noise control and surveillance within the European Union. The Environmental Noise Directive was set to determine levels of noise exposure, increase public access to information regarding environmental noise, and reduce environmental noise. Additionally, in the European Union, underwater noise is a pollutant according to the Marine Strategy Framework Directive (MSFD). The MSFD requires EU Member States to achieve or maintain Good Environmental Status, meaning that the "introduction of energy, including underwater noise, is at levels that do not adversely affect the marine environment".
Exposure to noise is associated with several negative health outcomes. Depending on duration and level of exposure, noise may cause or increase the likelihood of hearing loss, high blood pressure, ischemic heart disease, sleep disturbances, injuries, and even decreased school performance. There are also causal relationships between noise and psychological effects such as annoyance, psychiatric disorders, and effects on psychosocial well-being.
Noise exposure has increasingly been identified as a public health issue, especially in an occupational setting, as demonstrated with the creation of NIOSH's Noise and Hearing Loss Prevention program. Noise has also proven to be an occupational hazard, as it is the most common work-related pollutant. Noise-induced hearing loss, when associated with noise exposure at the workplace is also called occupational hearing loss.
While noise-induced hearing loss is permanent, it is also very preventable. Particularly in the workplace, regulations may exist depicting maximum allowed levels of noise. This can be especially important for professionals working in settings with consistent exposure to loud sounds, such as musicians, music teachers and sound engineers. Examples of measures taken to prevent noise-induced hearing loss in the workplace include engineering noise control, the Buy-Quiet initiative, creation of the Safe-in-Sound Award, and noise surveillance.
Roland Barthes distinguishes between physiological noise, which is merely heard, and psychological noise, which is actively listened to. Physiological noise is felt subconsciously as the vibrations of the noise (sound) waves physically interact with the body while psychological noise is perceived as our conscious awareness shifts its attention to that noise.
Luigi Russolo, one of the first composers of noise music, wrote the essay The Art of Noises. He argues that any kind of noise could be used as music, as audiences become more familiar with noises caused by technological advancements; noise has become so prominent that pure sound no longer exists.